Weave one flat strip over and under four fixed strips

Original, untested video brief. No input image or generated result is supplied.

1. Task and boundary

Advance one flexible flat strip across four separate fixed strips, passing over the first, under the second, over the third and under the fourth. Follow the same leading tip through each crossing and finish with a loose woven row that exposes the route.

This untested routing brief uses broad plain strips in an open raised frame. Exclude knitting, knot tightening and a finished textile appearing by transformation.

2. Authorized first frame

Use a photograph or accurate drawing you own or have permission to use. Four parallel strips run away from the camera across a raised frame, held at both ends. A separate crosswise strip begins to their left, with a distinct plain tip held by one original hand.

Choose an oblique overhead view showing the gaps and the space beneath the fixed strips. Leave room for the moving tip beyond the fourth strip and for its trailing length on the left.

3. Use the generator

Open the current image-to-video generator in a mode accepting your authorized first frame. Paste the prompt; check settings and cost before submission. Nothing runs automatically.

4. Prompt and timing

Start from my authorized image of four parallel plain strips fixed across an open raised frame and one separate flexible strip held at its leading tip. Keep the camera, lighting, frame and four fixed-strip endpoints stationary. Move the original leading tip from left to right in one weaving pass. Carry it over the first fixed strip, through the open gap, under the second, through the next gap, over the third and under the fourth. At each crossing, preserve the correct front-back occlusion: the moving strip is visible above the first and third strips, and hidden only where it passes below the second and fourth. Let the trailing length follow the same route without changing previously formed crossings. Use gentle local bends and visible gaps, not penetration through solid material. Keep all strips separate and continuous. Stop with the tip visible beyond the fourth strip and a loose woven row still inside the frame. No knot, extra strip, instant finished fabric, tightening cycle, transparent material, cut or camera movement.

1. Establish, first fifth: identify the four fixed strips from left to right and locate the moving tip.
2. Weave, middle three fifths: inspect each of the four crossings in order; keep earlier crossings visible while the next forms.
3. Hold, final fifth: show the emerged tip, trailing length and the complete alternating row without pulling it tight.

5. Inspect the output

For each check, record a frame or time, observation and pass, fail or inconclusive judgment.

• The same leading tip approaches and emerges from each crossing in the intended order.
• Crossings one and three show the moving strip above; crossings two and four show it below.
• Every hidden interval is bounded by matching visible segments on either side of the fixed strip.
• Earlier crossings retain their over-under order as more trailing material follows.
• The frame and four endpoint pairs stay fixed; no strip tears, splits or merges.
• If a hand hides a crossing during formation and the later route remains ambiguous, record that crossing as inconclusive.

6. Fix one failure

• Everything stays on top: use a clearer raised frame and explicitly identify the second and fourth underpasses.
• The tip teleports across a strip: slow that crossing and retain visible approach and emergence on both sides.
• Earlier crossings swap order: keep the trailing strip on its already established route rather than redrawing the whole weave.
• The moving strip becomes several pieces: use one distinguishable tip and follow continuous side edges between crossings.
• Hands block the route: shift the authorized grip toward the tip end and use a more oblique view.

7. Ending and limits

Finish with one continuous loose crosswise strip alternating through the same four fixed strips, its two ends visible.

Save your result, authorized input, exact prompt, settings and inspection notes.

No H3 output, textile strength test, friction measurement or hidden geometry reconstruction is supplied. The inspection establishes only the visible route in this proposed shot.

The eyelet task advances a cord through one rigid opening; the knot task preserves existing self-crossings. Here four new alternating crossings form between separate strips. Changing their colors alone remains the same task.