Task template
MiniMax H3 screw-cap prompt: rotate the cap and grow the neck gap
Plan a small coordinated cap turn and axial lift above a stationary jar. Track the cap mark, growing neck gap and fixed body with an original practice PNG.
MiniMax-H3 · image-to-video · Original task method; generation has not been independently verified.
Start generating video →
MiniMax H3 screw-cap prompt: rotate the cap and grow the neck gap
Loosen an unbranded screw cap with a small axial lift during its partial turn, so the neck gap grows continuously. Distinguish that linked motion from a hinged lid, a straight lift or a rotating whole bottle.
Original illustrated practice input; method not independently tested. No H3 generation or model output is supplied. A result, if you later generate one, still needs the checks below.
!Original illustrated practice input, not a model result
Read the starting input
The illustration shows a broad teal jar, a shallow orange cap and one pale radial cap mark. A short neck is visible below the cap; the jar body rests on a table. The diagram is not a depiction of a particular package or thread pitch.
Track the jar's lower corners, the cap mark and the dark horizontal neck gap. The cap and body must remain independently identifiable.
Set up the current generator
Select MiniMax H3 base in image-to-video. Enable Add end frame so the current interface exposes the First Frame slot. Upload only first-frame.png to First Frame and leave Last Frame empty. This is not the Fast workflow: Fast requires both frames. Select a duration and ratio actually offered by the interface; these notes promise no exact motion timing. Opening a generator does not submit a task. The SVG is a design/inspection source, not an upload instruction.
Download practice kit · PNG first frame · Blank acceptance sheet
Copy the original prompt
Start from the original illustrated frame. Fixed front-oblique close-up. Hold the teal jar body stationary on the table. Slowly turn only the orange screw cap through a small partial turn while it rises slightly along the jar neck, so the visible neck gap increases progressively during the same turn. Keep the cap centered over the mouth, with the same pale mark attached to its top. Do not swing it on a hinge, rotate the jar body, replace the contents or send the cap flying away. End with the cap just loosened and slightly above its starting height, then hold. No full opening reveal or camera move.Work through one attempt
- Locate the cap mark and the initial neck gap before trying the prompt. A blank circular cap without an asymmetric mark makes small rotations hard to distinguish.
- Request only a partial turn with a small rise during that same motion. Leave removal, a hand grip and a contents reveal for separate shots so that the cap-neck relationship stays readable.
- Compare the top mark and neck gap at the same pauses. If only the gap changes, it may be a straight lift; if the entire jar turns, the intended separation of roles has failed.
Inspect the result
Record an observation for each item in the blank sheet. The sheet starts with empty results: none is a pre-existing pass.
- The jar body stays planted at its original table position.
- The cap mark changes orientation with the cap, without sliding over its surface.
- During the partial turn, the cap rises slightly and the visible neck gap grows while the cap remains centered.
- The ending keeps cap and neck visible without a hinge or an invented contents reveal.
Change one failure at a time
- Cap becomes a hinged lid: remove lid-opening language and specify a centered screw cap.
- Cap jumps away: shorten the rise and stop at a just-loosened state.
- Whole jar rotates: fix the body and name the cap mark as the only rotating graphic.
Ending, limits and related tasks
The unchanged jar remains planted, with its marked cap slightly turned and raised above the original neck gap.
This is a visual rotation-and-lift brief. It does not verify a thread pitch, torque, seal integrity or packaging performance.
The hinged-box page has one fixed hinge; the bottle-light page moves illumination without rotating the object. This task needs a centered cap to rotate and lift.
