Task template
MiniMax H3 bubble-release prompt: detach one bubble from a fixed ring
Plan one bubble's short emergence and release from an original ring illustration. Inspect the narrowing neck, single detached bubble and unchanged wand instead of adding a bubble cloud.
MiniMax-H3 · image-to-video · Original task method; generation has not been independently verified.
Start generating video →
MiniMax H3 bubble-release prompt: detach one bubble from a fixed ring
Extend an already bulging soap film slightly and detach one bubble from its ring. The task follows a single visible connection becoming a single separate object.
Original illustrated practice input; method not independently tested. No H3 generation or model output is supplied. A result, if you later generate one, still needs the checks below.
!Original illustrated practice input, not a model result
Read the starting input
The original illustration shows a teal wand with a large circular ring, a pale film bulging to the right and a short connecting neck. The background is plain, with no face, mouth, soap brand or claimed real surface physics.
Keep the wand handle and ring center fixed. Follow the film neck at the ring opening and keep the emerging bubble singular throughout the short action.
Set up the current generator
Select MiniMax H3 base in image-to-video. Enable Add end frame so the current interface exposes the First Frame slot. Upload only first-frame.png to First Frame and leave Last Frame empty. This is not the Fast workflow: Fast requires both frames. Select a duration and ratio actually offered by the interface; these notes promise no exact motion timing. Opening a generator does not submit a task. The SVG is a design/inspection source, not an upload instruction.
Download practice kit · PNG first frame · Blank acceptance sheet
Copy the original prompt
Begin with the supplied schematic first frame. Fixed close camera and stationary teal wand. The one pale soap-film bulge extends a little toward frame right while connected to the existing ring by a narrowing film neck. The neck then closes and one single bubble detaches, drifting only a short distance right. Keep the ring round and unchanged; no extra bubbles, pouring liquid, face, hand, burst or scene cut. Finish with the ring on the left and the one detached bubble still fully visible on the right, then hold.Work through one attempt
- Start with the existing bulge, not an empty ring. This isolates release from the separate actions of dipping a wand and blowing air.
- Keep the detached travel short and do not request a bubble cloud or a pop. The separation should remain large enough in frame to inspect.
- Pause before neck closure, just after detachment and at the ending. A bubble simply appearing beside the wand does not show the required connection-and-release sequence.
Inspect the result
Record an observation for each item in the blank sheet. The sheet starts with empty results: none is a pre-existing pass.
- The wand and ring remain stationary and keep their original shape.
- One bulge remains connected by a visible narrowing neck before release.
- Exactly one bubble separates from that neck without duplicating.
- The detached bubble remains fully visible and unburst in the ending.
Change one failure at a time
- Many bubbles appear: remove decorative bubble-cloud language and specify one connected bulge.
- Bubble pops: end at short post-release drift and exclude bursting.
- Wand bends to create the gap: fix the ring and make the film neck the changing part.
Ending, limits and related tasks
The original ring remains left of one fully visible detached bubble, without a burst or additional bubbles.
This is a schematic topology-continuity exercise, not a surface-tension simulation, fluid measurement or tested H3 bubble effect.
The pour page maintains a stream and level relationship; the drop page begins with a separate solid object. This task starts with a connected film neck and ends with one separation.
