Pack the visible items of a travel kit

1. Task and boundary

Make a short packing demonstration that explains where the visible travel items go. Use only two items and keep the pouch open throughout. Their upper portions remain visible at the end, so the viewer can connect the starting items with the packed arrangement without relying on disappearance behind fabric.

The related drawstring task changes a pouch opening. This task leaves the opening available and follows the visible items into storage one at a time. See MiniMax H3 drawstring prompt: gather one pouch opening without changing its body.

Replace the two real item descriptions and insertion order to match the items in your image. This short version ends open; it does not demonstrate zipper closure, waterproofing or a measured storage capacity. Do not request more items than the visible pouch can plausibly hold.

2. Authorized first frame

Use an original or authorized tabletop view of a shallow, open pouch wide enough for two small items. Place a slim case and travel bottle beside it, each taller than the rim so its top can remain visible. Show one hand at the rim and the other ready to grasp the first item; keep the full approach paths clear.

3. Use the generator

Open the image-to-video generator, supply your authorized first frame and paste the prompt. Check available settings and cost before submitting; this page does not upload or submit for you.

1. Opening: identify the empty opening, slim case, bottle and stabilizing hand.
2. Action: insert the case, release it, then insert the bottle along a separate clear route.
3. Ending: retain the open rim and visible item tops so the starting and packed states can be compared.

4. Prompt and timing

Use the supplied first frame with a fixed camera. Keep the open pouch on the table. One hand steadies its rim while the other picks up the existing slim case and lowers it through the opening into the left side. Release it only after it is supported inside. Then use the same hand to pick up the existing travel bottle and lower it through the opening into the right side. Preserve both items and their separate colors and shapes. Keep their upper portions visible above the rim at the ending. Move the packing hand clear and hold. Do not add items, pass through the pouch wall, enlarge the pouch or close it.

5. Inspect the output

Inspect the opening, action and ending. Record a frame and pass, fail or inconclusive for each criterion; mark hidden or unreadable details inconclusive.

• Only the two starting items are packed, in the stated order, without duplication or identity swapping.
• Each item visibly travels through the existing opening instead of vanishing beside the bag.
• The final upper portions remain identifiable; the pouch stays on the table without unexplained expansion.

6. Fix one failure

• If an item disappears beside the pouch, use a higher viewing angle that shows its route through the rim.
• If the bag grows, reduce the item size or use a source that visibly provides enough room.
• If identities swap, use two distinct shapes and keep the order fixed instead of adding more items.

7. Ending and limits

The same two items sit separately inside the still-open pouch, with their upper portions visible and the packing hand clear.

Original, untested shot brief; no generated sample is supplied. Check the actual motion as well as the ending, and do not treat an attractive result as proof of a product claim.

Save your output with the authorized input, exact prompt, actual settings and inspection notes using the available result controls.

Original, untested video brief. No input image or generated result is supplied.

• MiniMax H3 drawstring prompt: gather one pouch opening without changing its body