Seat a tote handle on a fixed hook before releasing

1. Task and boundary

Make a short storage demonstration with one lightweight tote and one fixed hook. The handle opening must travel over the hook tip before the bag is lowered. Release the hand only after the original loop is visibly seated in the hook bend.

The key relationship is threading a closed handle opening over a fixed hook before transferring support. The hook tip, loop and release must all be visible in sequence.

Change the bag fabric, wall and hook appearance to match your image. Keep one closed loop with two visible attachment points; do not add handles or a new wall fitting.

2. Authorized first frame

Use an original or authorized image of a fixed upward hook and an empty lightweight tote with one wide handle loop. An adult hand supports the top of the open loop close to, but not already behind, the hook tip. Show the whole loop and its two bag attachments.

3. Use the generator

Open the image-to-video generator, add your authorized first frame and paste the prompt. Check current options and cost before you submit; this page does not upload or submit on your behalf.

1. Choose a single-handle tote and a hook with an exposed upward tip; avoid overlapping handles.
2. Frame the opening and both bag attachment points without cropping the hook.
3. Describe the over-tip movement, short lowering and release in that order.
4. Inspect the last contact frames before the hand withdraws, not just the hanging result.

4. Prompt and timing

Locked close three-quarter view of one fixed upward-curved wall hook and the same lightweight tote. An adult hand holds the top of the single wide handle loop open just in front of the hook tip. Move the loop over the visible tip, then lower it a short distance into the hook bend. Keep the loop continuous and attached to its original two points on the bag. Once seated, the fingers open and move away; the bag remains suspended from the hook with only a small settling movement. Keep the wall and hook fixed. No loop cutting, hook penetration, extra straps or unsupported jump.

5. Inspect the output

Inspect the actual clip from start to finish. Use pass, fail or not visible for each check; an attractive final frame does not prove the intervening motion.

• The original hook tip passes through the handle opening rather than through the strap material.
• The same loop remains connected to the same two bag attachment points.
• The loop settles into the hook bend before the hand opens.
• After release, the bag stays below the seated loop without a new support or a disappearing strap.

6. Fix one failure

• If the strap cuts through the hook, choose a more open initial loop and a smaller approach distance.
• If the bag jumps into place, start closer to the tip while keeping a visible gap.
• If release happens early, shorten the shot to seating followed by one clear finger-opening action.

7. Ending and limits

Finish with the hand separated, the original loop visible in the hook bend and the bag hanging below it.

This does not certify hook strength, attachment security or a real bag weight limit. Use a visually light empty bag and do not infer load capacity from generated hanging motion.

After inspecting a result, use the available result-save or download control. Keep the first frame, exact prompt and complete output together so that revisions can be compared.

This is an original prompt design with visual acceptance criteria, not a generated demonstration or a tested model-performance claim.

• One object, two hands: support the handoff before releasing