Squeeze a short toothpaste ribbon onto the bristles

1. Task and boundary

Show a small amount of toothpaste being transferred from an open tube to a stationary brush. Place the nozzle close to the bristles in the first frame and request one gentle squeeze. The useful result is a short supported ribbon, not a floating or endlessly growing strand.

The task joins three visible stages: compression of a soft tube, extrusion through its fixed outlet and deposition on a separate support. The destination is as important as the outlet.

Match tube and brush appearance to your image. Use an already open nozzle and an uncovered brush; do not combine cap removal or toothbrushing with this transfer.

2. Authorized first frame

Use an original or authorized close image of a stationary toothbrush with its bristles visible and an uncapped toothpaste tube held by an adult hand. The original nozzle points down toward the bristle center from a small visible gap. Keep the tube outlet and brush head unobstructed.

3. Use the generator

Open the image-to-video generator, add your authorized first frame and paste the prompt. Check current options and cost before you submit; this page does not upload or submit on your behalf.

1. Choose a near side view that exposes the nozzle opening and the top of the entire brush head.
2. Keep the first-frame gap small and aim toward the center of the bristles, not their side.
3. Request a short squeeze followed by stopping the flow and a small separation.
4. Inspect the ribbon at the outlet and at the brush before accepting the final deposited shape.

4. Prompt and timing

Locked side close-up of the original open toothpaste tube and stationary toothbrush. An adult hand gently compresses the same tube once. A short ribbon of paste emerges only from the original nozzle, crosses the small existing gap and settles onto the center of the bristles. Keep the brush, bristle groups, nozzle and hand grip unchanged; let the tube body dent slightly under the fingers. Stop squeezing, stop the flow and move the nozzle just clear so one short paste ribbon stays on the brush. No paste through the tube wall, floating strand, extra brush or long coil.

5. Inspect the output

Inspect the actual clip from start to finish. Use pass, fail or not visible for each check; an attractive final frame does not prove the intervening motion.

• The tube changes shape only at the original finger pressure while its nozzle remains connected.
• Paste is visibly connected to the original outlet during extrusion, with no second source.
• The short ribbon meets the bristles and remains supported above the brush head.
• Flow stops before the nozzle clears; the deposited ribbon remains without continuing to grow.

6. Fix one failure

• If paste starts on the brush without a visible route, reduce the initial gap and emphasize the existing outlet.
• If paste falls through the bristles, expose the top supporting surface and ask for a shorter ribbon.
• If the strand grows indefinitely, remove decorative coils and keep the stop-squeezing stage explicit.

7. Ending and limits

Hold the nozzle just clear of the brush and keep the short paste ribbon on the bristles. End before bringing anything toward a mouth.

The design does not specify a recommended toothpaste dose, prove product consistency or demonstrate oral-health effects. Generated volume and flow are visual intentions rather than measurements.

After inspecting a result, use the available result-save or download control. Keep the first frame, exact prompt and complete output together so that revisions can be compared.

This is an original prompt design with visual acceptance criteria, not a generated demonstration or a tested model-performance claim.

• One short pour: check the stream, rim and rising liquid level