Complete one knitting loop transfer between two needles

Original, untested video brief. No input image or generated result is supplied.

1. Task and boundary

Complete one partly prepared knit stitch. A new loop is already caught on the receiving needle and partly drawn through the old loop. Draw it clear, then let the old loop leave the source needle while remaining interlocked with the new loop. Track which needle supports each loop.

This original plan is untested. Begin at the specified mid-stitch arrangement. Exclude cast-on, repeated rows and exact tension claims. Inspect one target stitch beside two unchanged neighbors.

2. Authorized first frame

Prepare a technically accurate photograph or drawing you own or are authorized to use. The left needle carries the target old loop nearest its tip and two neighboring loops farther back. The right needle has entered the target and holds a small new working-yarn loop partly pulled through it.

Use thick plain yarn and an oblique close-up showing both needle tips, the target opening, the new loop and attached fabric below. Two original hands hold the needles away from the crossing. Trace the working yarn into the new loop before drafting; if its path is impossible or hidden, correct the input first.

3. Use the generator

Open the current image-to-video generator in a mode accepting your authorized first frame. Paste the prompt; check settings and cost before submission. Nothing runs automatically.

4. Prompt and timing

Start from my authorized accurate mid-stitch image: the target old loop is near the left needle tip, and the right needle already holds a small new yarn loop partly drawn through it. Keep the camera, yarn identity and two neighboring left-needle loops stable. Move the right needle enough to draw the same new loop fully through the old opening while retaining it around the right needle. Then advance the old target loop toward and off the left needle tip. Let that old loop remain part of the attached fabric, interlocked through the new loop; it must not vanish or detach as scrap. End with the new loop supported on the right needle and the two neighboring loops still on the left. Preserve rigid needle tips, continuous working yarn and both hand connections. No new row, extra stitch, cut, broken yarn or repeated transfer.

1. Opening fifth: distinguish the old target loop from the new partly drawn loop and the two untouched neighbors.
2. Middle three fifths: inspect the new loop clearing the old opening, followed by the old loop leaving the left tip.
3. Final fifth: compare needle occupancy and trace the old loop into the fabric beneath the retained new loop.

5. Inspect the output

For each check, record a frame or time, observation and pass, fail or inconclusive judgment.

• The same new loop passes through the existing target opening rather than through solid yarn.
• The right needle retains the new loop before the old one leaves the left tip.
• Exactly the selected old loop leaves the left needle; both neighboring loops remain.
• The released old loop stays connected to the fabric and visibly interlocked with the new loop.
• Both needles remain rigid and the working yarn stays continuous.
• If either loop is completely hidden during the exchange, mark the interlock inconclusive; a changed stitch count alone cannot prove the route.

6. Fix one failure

• Fabric grows without a transfer: track the two named loops separately and end after this stitch.
• The old loop disappears: retain its route into the fabric below the needles.
• Both loops fall off: keep the receiving loop around the right needle before moving the old loop.
• Yarn passes through a needle shaft: correct the input geometry and preserve the visible needle tips throughout.

7. Ending and limits

End with the new loop on the right needle, two untouched loops on the left and the old target loop joined into the fabric below.

Save your result, authorized input, exact prompt, settings and inspection notes.

No generated output, stitch-quality certification or tension measurement is supplied. Hidden yarn paths remain outside the visible checks.

The knit-unfolding task moves existing fabric without making a stitch. Separate-strip weaving forms alternating crossings between strips; this task draws a new yarn loop through an old one and changes their needle support.