Open a gate and remove a rope loop sideways

Original, untested video brief. No input image or generated result is supplied.

1. Task and boundary

Press open the gate of one fixed carabiner and draw an existing rope bight through the side opening. The folded rope section leaves without threading either free end through the frame. Release the gate after the bight clears and finish with the closed empty frame beside the intact rope.

This original motion plan is untested. Use a plain unloaded demonstration connector with a visible hinged gate. Exclude climbing use, load ratings, lock verification and a closed ring through which solid rope passes without an opening.

2. Authorized first frame

Use a photograph or accurate drawing you own or have permission to use. Show the carabiner held fixed against a plain surface. One rope bight sits inside its frame while both continuing rope lengths extend outside the lower frame area.

Keep the gate hinge, gate tip and rope fold visible. The original hands are positioned to press the gate and guide the bight, without covering the opening. Choose a broad gate and a simple rope route with no knot or additional connector.

3. Use the generator

Open the current image-to-video generator in a mode accepting your authorized first frame. Paste the prompt; check settings and cost before submission. Nothing runs automatically.

4. Prompt and timing

Start from my authorized image of a fixed carabiner holding one rope bight, with the gate hinge, gate tip and original operating hands visible. Lock the camera and carabiner frame. Press the existing gate inward around its hinge until a visible side opening forms. Keep the frame rigid. Draw the same folded rope section sideways through that opening while both continuing rope lengths remain connected to it. Do not pull a free rope end through the frame or let the rope cross solid metal. Once the entire bight is outside, release the gate and let its tip return to the original nose. Hold the empty closed frame beside the intact rope. Preserve the hinge and both rope branches. No extra cut, knot, detached gate, duplicate connector, camera move, load claim or lettering.

1. Establish, first fifth: trace the folded rope route and locate the closed gate.
2. Open and remove, middle three fifths: show the gap first, then the whole bight crossing the opening.
3. Close, final fifth: return the gate after clearance and inspect the empty frame.

5. Inspect the output

For each check, record a frame or time, observation and pass, fail or inconclusive judgment.

• The gate opens about its original hinge before rope crossing.
• The rope passes through the visible gap rather than the solid frame.
• The bight and both branches remain one continuous rope route.
• Neither free rope end is introduced as a substitute for the folded section.
• The gate closes only after the rope is fully clear.
• If the opening is hidden during passage, mark side-exit continuity inconclusive.

6. Fix one failure

• The rope crosses metal: widen the readable gate opening before moving it.
• The gate detaches: preserve its single hinge throughout the press.
• The rope becomes two pieces: retain the folded bend between its branches.
• The gate closes on the rope: insert a clear fully-outside beat before release.
• The connector turns with the pull: anchor the outer frame against the background.

7. Ending and limits

End with the original gate shut, the frame empty and the same continuous rope bight outside it.

Save your result, authorized input, exact prompt, settings and inspection notes.

No H3 output, hardware test or safety certification is supplied. Visible closure does not establish a locking state or suitability for any load-bearing use.

The fixed-eyelet task advances a rope end through an unchanged hole. Here the boundary opens temporarily so a folded middle section can leave sideways.