# MiniMax H3 label-peeling prompt: move the contact boundary, keep the panel fixed

Animate a partly lifted blank adhesive label peeling a little farther from a rigid panel. Judge the changing attached region rather than a general hand movement or a whole-object reveal.

Original synthetic practice still, not a generated result. No model run has been performed.

Files: first-frame.png (1024×1024 actual first-frame input), first-frame.svg (editable geometric design source; do not upload as if it were PNG), prompt.en.txt / prompt.zh.txt, acceptance.blank.csv (all observations empty), task-definition.json and RIGHTS-REVIEW.txt.

## Generator

Use MiniMax H3 base image-to-video. Turn on Add end frame to expose First Frame, upload first-frame.png only, and leave Last Frame empty. Fast requires a pair and is not covered. Choose only options offered by the current interface; opening it does not submit.

## Starting state

The square illustration shows a beige panel, a white rectangular label and a small folded free corner at the upper right. The remaining flat label is still attached. There is no logo, lettering or hidden product artwork to invent.

Use the panel's four outer corners as fixed anchors. Follow the diagonal fold where the lifted corner meets the attached sheet; this line is the adhesion boundary, not a printed decoration.

## Steps

1. Before submitting, trace the panel corners, attached sheet and free flap in the PNG. If you replace the drawing, start with an actually lifted corner; a completely flat sticker hides the motion's starting condition.
2. Ask for only a short peel. Keep removal, reapplication and a hand entering the frame out of this first attempt, so a change of contact is the main event.
3. When you have a result, pause at the start, the largest visible change of the fold and the ending. Compare the revealed region with the fold's travel, rather than assuming a plausible-looking flap proves correct contact.

## Acceptance

- All four panel corners stay in place without a camera-induced scale change.
- New beige surface appears only behind the advancing peel boundary.
- The free flap remains joined to the attached sheet; it does not become a second label.
- The ending still contains an attached region and one lifted flap.

## Limits

This brief checks visible attachment continuity. It does not simulate adhesive strength, material stiffness or a measured peel angle.

Read prompt.en.txt before submitting. No pass results or output video are included.